Difference between revisions of "CISN Display CentOS"
From Stadm
Jump to navigationJump to search (→Setup) |
|||
| Line 11: | Line 11: | ||
==Setup== | ==Setup== | ||
*Install centos 6 on a compatible system, we will use a script that runs off this machine | *Install centos 6 on a compatible system, we will use a script that runs off this machine | ||
| + | **note:have not tested on centos minimal, install centos with a gui, script can be run remotely | ||
*once installed run the following script to get the CISN Display installed as a kiosk | *once installed run the following script to get the CISN Display installed as a kiosk | ||
| + | |||
==Additional Steps== | ==Additional Steps== | ||
*after restart you have to type in credentials for cisn_display | *after restart you have to type in credentials for cisn_display | ||
Revision as of 12:31, 16 December 2015
Introduction
This page will attempt to document the creation of a kiosk type display of the CISN Display. The CISN Display software displays near real-time earthquake location information available via the network. A complementary component would be a waveform viewer showing seismograms (in real time) from various locations around California (or beyond), but we have not had time to mount a concerted effort along those lines yet.
Historical Notes
Installation Guide
Setup
- Install centos 6 on a compatible system, we will use a script that runs off this machine
- note:have not tested on centos minimal, install centos with a gui, script can be run remotely
- once installed run the following script to get the CISN Display installed as a kiosk
Additional Steps
- after restart you have to type in credentials for cisn_display
